Enter your keyword

Daisy Flower Tutorial

Daisy Flower Tutorial

Daisy Flower Tutorial

Original source: http://www.allthingspaper.net/2011/04/quilled-daisy-card.html

 

Tutorial: Daisy Flower

Supplies:

Cardstock – peach, hot pink, white
Quilling paper – 1/8 inch standard width strips OR cut your own from any light to medium-weight paper; not cardstock
Quilling tool – slotted or needle tool OR use a stiff wire, cake tester, or a even a round cocktail stick
Double-stick tape or glue stick – to adhere card layers
Glue – liquid, any type that is suitable for paper
Scissors
Ruler
Tweezers
Paper cutter
Glass head straight pin
Non-stick surface to use as glue palette and workboard – an acrylic sheet, waxed paper, or Styrofoam tray
Adhesive foam dimensional dots
Moist cloth – to keep fingers glue-free and to dampen fingertips when rolling quilling paper

Directions:

1. The card measures 5.5 inches square and the hot pink interior square is a bit larger than 3 inches square. Cut a white square that is just a bit larger than the pink one. Adhere the pink square to the center of the white one with double-stick tape or a glue stick.

2. Glue two strips of quilling paper together lengthwise and set them aside to dry while making the other quilled components. This will be the stem and tiny straight bits. I use clear craft glue and if any gets on the outer edges of the strips, I run a damp cloth down both sides to wipe it away.

3. Make two 12 inch shaped marquises for the leaves. Make a marquise shape by rolling the strip on a quilling tool, allow the coil to relax, slip it off the tool, pinch two opposing points, glue and trim end. Hold each end of the marquise between thumbs and index fingers and shape it gently, one end up and one end down so it looks leaf-like.

4. Make a 7 inch domed tight coil as the flower center. Roll the strip on quilling tool. Glue the end in place before allowing the coil to relax. Slip coil off tool. Give the coil a domed top by pressing a fingertip against one flat side to curve it. Apply a thin coating of glue inside the dome to preserve the shape.

5. Make 8 ring coils by wrapping the paper around a 1/2 inch diameter cylinder 4 times. I used my quilling tool handle. Slip the coil off the tool and pinch one end to a point, creating a teardrop shape. Glue and trim end.

6. Make 2.5 inch tight coils (7) as the outer beads and 3 inch tight coils (8) as the inner beads. Same method as in Step 4.

7. Snip straight, double-thickness pieces – 3/4 inch (7) and 1/4 inch (8) – one for each tight coil.

8. Cut a 3 inch strip from the double-thickness strip and curve it slightly between thumb and index finger as the stem.

9. Use tweezers to assemble the flower on a nonstick surface, such as a sheet of acrylic. Remember that less glue is best for a neat result. When gluing the competed flower to the cardstock, I find it works well to spread a thin layer of glue on the acrylic. Touch the flower to the glue, then place it directly on the pink square.

10. Last of all, apply adhesive foam dimensional dots to the back of the white square and adhere it to the center of the peach card.

11. Send it or frame it!