Slotted quilling tool – to roll the center coil; substitute a stiff wire/cake tester/cocktail stick if you don’t have a tool
Glue – I use a clear gel adhesive. White glue that dries clear would be fine too.
Plastic lid or contact lens case – use as glue palette
Paper piercing tool or cocktail stick – to apply glue
Scissors – detail
Straight pin with ball head
Ornament cord – gold/silver
For each layered snowflake, you’ll make 18 snowflake arms in three sizes – small, medium, and large, 6 of each. (what? you didn’t realize snowflakes have arms? oh they do!) My three sizes measure .50 inch (13mm), .75 inch (19mm), and 1 inch (25mm), and the completed snowflake is a bit wider than 2 inches (5cm). You’ll also need to make one quilled tight coil to tidy up the center space.
Perhaps you’ve noticed there are only 17 arms in the photo. That’s because we’re going to make the last one together!
e. Glue the end in place and gently pinch the top of the collar to create a point at the tip.
f. Trim excess strip at the bottom. Tip: If you run out of paper while making loops, glue and trim excess at bottom, then glue the end of another strip in place and carry on making loops and collar.
Step 2: Make a tight coil center.
a. Slide one end of a 3-inch quilling strip into the quilling tool slot. Turn the tool to roll the paper into a tight coil. Hold the coil end in place and pick up a tiny amount of glue from your plastic palette with the tip of a paper piercing tool or cocktail stick. Touch the glue to the strip end, hold it in place for a few moments, then slide the coil off the tool. Tip: A torn strip end blends/looks better than a sharply cut end.
b. Press the ball head of a straight pin against one side of the tight coil to create a small dome. Apply a bit of glue inside the dome to preserve the rounded shape.
Step 3: Assemble snowflake.
a. Glue 6 of each arm size in a circle as shown above; allow glue to set, then apply glue to the under-center of the medium arm layer and stack it on top of the large arm layer, taking care to stagger arms so they aren’t positioned directly over one another. Repeat with the small arm layer. Tip: Tweezers help a lot at this stage of the game.
b. Glue the domed tight coil in the center of the snowflake.
c. Fold a short strip of quilling paper in half and glue it as a reinforcing layer around the collar of the arm you’ve chosen to be the ornament top.
d. Fold a 10-inch piece of metallic cord in half and slip loop end through the reinforced collar and longest loop. Slip the loose ends through the loop and tie ends in a knot. Hang the ornament on your Christmas tree or in a window to enjoy all winter long. You could even attach a jump ring and chain instead of the cord and wear it as a necklace.
Are you curious about the second most frequently searched for item on this blog? Folded book patterns! Kate of Kate’s Creative Space shared how to make several really nice folded books last year so I’ll send you over there to get the full deets.
Lastly… The Paper Assembly international giveaway of a dozen large sheets of decorative artist paper for collage, bookbinding, box making, and even gift wrapping is underway through Sunday, December 7, 2014. If you win, you’ll get to choose your papers!